Basic Wireless settings for tengda wireless router settings

Tengda Wireless RouterThe basic settings are as follows:

EnableWirelessFunction: "select" and enable the wireless function. If you do not want to use wireless, you can cancel the selection. All wireless-related functions are disabled;

Wireless working mode: tengda wireless router provides two wireless working modes, Wireless Access Point AP) and bridge WDS ).

Tengda wireless router Wireless Configuration-Wireless Access Point AP)

Network Mode: select one mode based on the wireless client type. The default value is 11b/g/n hybrid mode.

11b mode: if only the 11b mode client exists in your wireless network, you can select this mode.

11g mode: This mode can be used if your wireless network only saves 11g mode clients.

11b/g hybrid mode: This mode can be used if your wireless network has a client in 11b or 11g mode.

11b/g/n hybrid mode: This mode is used if your wireless network has 11b, 11g, and 11n clients.

SSID: the name of the Service Set Identifier and wireless signal network, which can be modified. The SSID is required.

Broadcast (SSID): "enabled" by default ". DisableVroBroadcast SSID. The wireless client cannot scan the SSID of the router. After "Disable" is selected, the client must know the vrossid SSID to communicate with the vro.

Channel: the channel currently used by the router. You can select another valid working channel from the drop-down list, which can be between 1 and 13.

WMM-Capable: enables wireless multimedia data transmission, for example, video or online playback. If you are not familiar with WMM, set it to enable it.

ASPD Capable: automatic power-saving mode, which is disabled by default.

Channel bandwidth: select a channel bandwidth to improve wireless performance. When there are 11b/g and 11n clients in the wireless network, you can select the 802.11n mode (wide) with a bandwidth of 20/40 M. When there are only non-11n clients in the wireless network, you can select the 20 M bandwidth mode. If the wireless network mode is 11n, select the 20/40 M band to increase its throughput.

Extended channel: used to determine the frequency segment of the network in 11n mode.

Tengda wireless router Wireless Configuration-bridge WDS) settings

WDS) is used to expand the coverage of existing wireless networks.

Ap mac address: Enter the MAC address of the Peer wireless device.

Note: The SSID must be the same as the Peer router.

The basic configuration process in the Wireless Configuration of the tengda wireless router is over, and there is not much content. It is not very difficult to perform the operation. As long as the step-by-step configuration is complete, you can try it again.