Boot press F1 to enter the system solution

We sometimes have a big string of English on the boot, which basically means that you press F1 to continue to start the crediting system. In this case, General computer beginners will press F1 every time to enter, so every time to turn on the computer, it is troublesome to teach you how to solve this problem.

The boot prompt should be in English: Hareware Monitor found an error,enter power MANAGEMENT SETUP for details,press F1 to Continue,del to enter SET Up.

And the Chinese explanation should be: monitoring function found error, enter the power MANAGEMENT Setup to see the details, press F1 key continue to boot program, press del key into COMs settings.

This problem is generally because some motherboards have hardware monitoring capabilities, can set the motherboard and CPU temperature monitoring, voltage regulator voltage output and monitor the speed of each fan, when the above monitoring function in the boot found abnormal situation, will appear above the English prompts.

The above prompts are mainly because the BIOS settings are inconsistent with the actual hardware data, settings and settings do not generally include the following aspects

1: The motherboard battery does not have electricity also can cause the data to lose thereby to appear this fault.

2: There is actually no floppy drive or the floppy drive is broken, and the BIOS is set up with a floppy drive, which causes to press F1 to continue.

The solution to several problems is roughly as follows:

One: If the motherboard battery is not electricity can change block motherboard battery, judge the motherboard battery has a method is to enter the system to see whether the system time is the same as the actual time, if not consistent with the general motherboard battery is dead, so you must change the battery.

Two: The problem of the floppy drive has several, the solution also has several kinds.

1: Reboot the system, into the BIOS setup, if you find that the floppy drive is set to 1.44M, but actually does not have a floppy drive, you need to replace the IDE secondary master auto to none.

2: Press the DEL to enter the motherboard BIOS, enter the boot start to set the boot sequence, turn off the floppy drive boot.

3: Can also turn off the boot detection function. Start the computer, and then press Del to enter the motherboard BIOS setup main interface, select the "Advanced BIOS Features" settings entry, and "boot up floppy seek" set to "Disabled", so that the boot software detection function can be turned off.

Note : More attention to the computer Tutorials section, triple Computer office group: 189034526 welcome you to join