Booz has to G3000 print when the paper error!

Booz has a small industrial barcode printer Postek G3000 Small industrial barcode printer, with a fully upgraded V3.0 motherboard with larger memory and faster print speed. In the price, performance, appearance, weight of the same type of machine on the obvious advantage. Here the key to the G3000 not only can connect computer printing, but also with the scanning gun and the single chip computer side sweep edge dozen or through the keyboard input for offline printing, real-time resolution of user label printing needs. Booz has to G3000 a highly recommended barcode printer.

If you are using Postek G3000 to print label paper, you find that the LCD displays a paper error (ready and the paper light flashes simultaneously), which means that the printer did not successfully detect your label, possibly for the following reasons:

One, the label run out

Please replace the new label and press the Cancel key or the feed key to resume printing after replacing.

Second, paper type is continuous paper

If you are using continuous paper (the label has no spacing and no markings, such as Figure 1 in the washing mark, you do not need to do the test paper operation, the paper will be the error, only the corresponding type of paper in the driver selected as a continuous paper can be.)

The drive changes the paper type to a continuous paper operation as follows:

After editing the label template in the Bartender software, click Print, then click the "Properties" button, select the "Volume" tab in the Pop-up Preferences dialog box, locate the "media type" and set it to: continuous paper.

Tip: When you are finished setting, save the label again so that the settings are lost when you open the label again.

Third, the label paper installation error

Please reinstall the label against the steps in the Quick installation guide that comes with random.

Four, did not carry out the test paper operation

If you are using a spacing or tagged label, you need to do a paper-measuring operation. Action steps are as follows:

①. In standby state, press the "Cancel" key and hold for 4 seconds, 3 LEDs will blink at the same time;

②. Immediately release the "Cancel" button and click the "Feed" button, the machine automatically walk paper (about 20 centimeters);

③.3 led led to stop flashing after the return to normal state, operation completed.

For a row of multiple-column labels, note the position of the paper detector, as shown in Figure 3:

Five, the label does not meet the requirements

Label sensor for photoelectric sensor components, by receiving from the label paper through or reflected back signal to identify the label, too thick or darker color of the label substrate may affect the printer to the label paper Detection.

If the back has a printed perforated tag, it is recommended to use a penetrating sensor for detection. The operation is as follows:

①. In standby state, click on the front panel "Pause" button, and then press 4 seconds "feed" key into the main menu;

②. Press "Cancel" key to switch menu to "printing mode", press "feed" key to enter the submenu, press "Cancel" key to switch to "heat sensitive" after press "feed" key confirm;

③. Press the Cancel key to switch to exit settings, press the "feed" key to confirm the exit and save, the operation completed.

Six, paper sensor dirty

Please clean the paper sensor with anhydrous alcohol and then do the paper-measuring operation.

Note: Please turn off the printer before cleaning the sensor.