Building Modeling Learning Notes 2--3dmax Housing Framework Modeling

The picture below is a broad framework made of 3DMax.

Here is a record of the key parts of the production

1. Snap switch

The snap switch is very useful when drawing, it can help you to quickly find the anchor point, so as to facilitate the object alignment or fixed point line position. In the drawing of the above graph, the method of capturing "vertex" can be used to make the above diagram. Snap switch capture mode is set up by right-clicking on the Capture button and the following dialog box pops up to select the vertex.

2. Drawing of walls

Import AutoCAD Drawing, turn on the snapping switch, draw the outline of the wall with the Dash tool, add the "extrude" modifier to the line, and set the quantity to 2800 (mm).

The Green line in the figure is the line of the AutoCAD drawing, and the white line is the outline of the wall we hook out, and the effect of adding the extrusion modifier is as follows:

We also need to add the "edit multi-morph" modifier, select the "element" option and click on the "Flip" button in the Modify option to flip the wall over and flip the effect as follows:

The red-framed part of the figure is the design of the sill door, which is described below.

2. Window sill/Door Making

This piece is in the edit multi-morph modifier

1) Select "Boundary", select the line you want to connect (such as line), click the button "Connect" in the tab, set the number of lines to 2 (two, indicating the upper and lower sides of the door) can be.

2) Move the new generation of the upper and lower two lines, the line distance from the bottom of the 2450mm, the line distance from 0mm, moving lines to the specific location there are two ways: we select the "Move" tool,

The first way: to adjust the absolute displacement, that is, to modify the z-axis value, such as:

The second way: adjust in a relative displacement way. First, you need to turn on snapping in vertex mode, move the top line to the top line position, and then modify the position in a relative position, such as:

(coordinates can be set in the lower right corner of the software)

3) After setting the line position of the door, select the "Multi-deformation" option, click on the keyboard "delete key", delete the face, then select the "Border" option, select the line of the door, click "Extrude" in the tab, set the height to 50. The setup process is as follows:

The production of window sill is exactly the same as that of the door.

3. Making of Bed frame

Draw the following lines in AutoCAD drawings, extrude the 2100mm height, then set the "Edit multiple variants" option, select "Multiple variants", select one side, click "Insert", select the ' group ' setting quantity is 50

Similarly, set the other three faces, then click the Extrude button, set the height to 50, delete the newly created face.

4. Making of Window glass

Draw a line in AutoCAD drawing, extrude the height of 2100mm, then select Line-〉 spline and set the contour to -25mm

Select the Segment tab to delete the selected segment

5. Production of suspended ceilings

The production of the ceiling is still drawing rectangular lines according to drawings, extrusion. At this point

1) The steps to draw the following effect are

Select the border rectangle, set the edit spline modifier, select spline, click the Attach button in the tab, check the Circle line and inner outline rectangle, and add the extrusion.

2) Draw the following effect

Select the Square object and select the Compound Object-〉 Boolean, in the Modify tab, click Pick Action Object B, select the difference set of a-a, click the cylinder, as

Summary: The above record is the important step to complete the building framework modeling. As we can see, drawing lines, extruding, editing multiple transformations or editing splines, these are the basic steps.

Copyright NOTICE: This article for Bo Master original article, without Bo Master permission not reproduced.

Building Modeling Learning Notes 2--3dmax Housing Framework Modeling