The
WAN
The port does not support proxy access. If you have already purchased a vro, please try the following operations.
I. Line connection
When a computer uses a proxy to access the Internet, all requests to access the Internet are sent to the proxy server. The proxy server obtains the relevant data from the Internet and then returns it back to the computer, as shown in the figure below:
After using the router, connect the broadband network cable to the WAN port of the router, and connect the computer to the LAN port of the router, as shown in the figure below:
II. Setting method
1
, Router WAN port configuration
① Cancel the proxy in the computer browser, connect the computer to the LAN port of the router using the network cable, and set the local connection of the computer
Auto get
IP
AddressLog on to the vro management page.
② According to the local connection settings when the computer directly connects to the broadband proxy for Internet access
Route settings
>
Internet settings,
WAN
Port connection type
Select
Automatically obtained
IP
AddressOr
Fixed
IP
Address. That is, if the local connection is set to automatically obtain the IP address when the computer is directly connected to the broadband network, the WAN port of the router is set to automatically obtain the IP address. If the local connection needs to be manually entered with the IP address, then, set the WAN port of the router to a fixed IP address and fill in the IP address, subnet mask, Gateway, DNS, and other parameters in the local connection.
③ Some proxies may be bound to a MAC address. You need to clone the MAC address of the computer to the WAN port of the router. In
Route settings
>
Internet settingsIn
Advanced Settings, Set
WAN
Port
MAC
Address
Select
Use current management
PC
Of
MAC
AddressAnd click
Save.
2
Terminal settings
① All terminals that connect to the vro through a wired or wireless connection will choose to automatically obtain the IP address.
② The terminal requires a proxy to access the Internet.
The computer settings are as follows:
Set
> Internet
Attribute
>
Connection
>
LAN settings, Select
Proxy ServerThe settings are as follows:
Note:: The address and port in the preceding figure are only for example. Refer to the actual address and port of the proxy server.
If the terminal is a mobile device such as a mobile phone or Pad, you also need to set up a proxy on the mobile phone or Pad. For specific settings, please contact the terminal customer service.
III. Notes
1. All terminal devices connected to the vro must be configured with a proxy to access the Internet.
2. After the terminal device sets proxy to access the Internet, the vro management interface cannot be accessed. Solution: add exceptions in the browser. Open the browser
Set
> Internet
Attribute
>
Connection
>
LAN settings, Click
Advanced, Add the management IP address of the router in the exception, as shown in the figure below: