Configuration of single-arm routing and DHCP for Cisco devices

Configuration of single-arm routing and DHCP for Cisco devices

In this experiment, we will configure single-arm routing and DHCP to enable the PC to automatically obtain IP addresses and achieve network-wide interconnection. Tutorial steps: 1. configure the IP address and gateway of the PC. add different VLANs to the vswitch and divide different network segments for the PC. 3. configure a single-arm route to achieve network-wide Interconnection (verification) 4. configure DHCP to verify that the PC can automatically obtain the IP address and ensure that the entire network is interconnected (verification) Start Operation: Step 1: configure the PC, here is an example of PC0, all other PCs except IP addresses and gateways are the same. Step 2: Configure switch switch0 and add vlan (1 ); add PC0 and PC1 to different VLANs and change the interface f0/23 to the relay mode (2). Configure the switch switch1 and change the three interfaces to the relay mode (3 ); the switch switch2 is the same as the switch switch0. Step 3: configure the single-arm route (1); Verify the network connectivity (2) Step 4: configure the DHCP router (1 ); verify the automatically obtained results (2 and 3); Verify the connectivity across the network (4)