Daily maintenance of memory strips common sense

The memory is important to the computer as if the heart is as important to us as human beings, and the maintenance of a memory bar is also very important to the operation of the computer. For memory, the need to note that in the upgrade of the memory bar, as far as possible to choose and the previous brand, FSB the same memory to use with the previous memory, so as to avoid the system is not working properly.

1. For dust caused by the memory of Gold fingers, graphics card oxidation layer failure, we apply rubber or cotton stained with alcohol cleaning, so it will not be black screen.

2. On the memory mix, when upgrading the memory, try to choose the same memory as you have, do not think that buying new mainstream memory will make your computer performance a lot, on the contrary, there may be many problems. The memory blending principle: Low spec, low standard memory is inserted into the first memory slot (i.e. DIMM1).

3. When only need to install a single memory, the preferred and CPU socket close to the memory sockets, the advantage is: When the CPU fan out of the dust pollution can be cleaned, and the outlet is contaminated after the extremely difficult to clean.

4. Install memory, DIMM groove on both sides have a card teeth, when the memory gap is correct, and plug in the bit, the two teeth should automatically "bite" memory. DDR Memory gold finger only a notch, the gap between the asymmetry, corresponding to the DIMM memory slot on a convex edge, so the direction is easy to determine. And for the previous SDR, there are two notches, it is easy to determine the direction, but the SDR has gradually faded out of the market, it is OK to understand it, and when pulling out the memory, you only need to move two teeth, memory will automatically from the DIMM (or RIMM) slot out.