Failure Phenomenon:
New consumption The YSZGN model installs the system BIOS debugging method as well as the common problems when installing the system.
Solution:
Tip: The following actions may result in an inability to access the system, and it is recommended that you back up your personal data and work under the guidance of a professional person.
1. Enter the "BIOS", select the Last "Exit" option, first select the "osoptimized Defaults" option to knock "Enter key" changed to "other OS" mode. Then select "Load Default Setting" to tap enter (enter) to select Yes to load the default value. The following figure:
2. Select the "boot" option above to change the "boot mode" and "Boot Priority" to the legacy opening mode. The following figure:
3. Finally press "F10" or "FN+F10" to choose Yes to save the exit. Then press "F12" or "fn+f12" to choose the CD-ROM or u disk boot installation system, you need to use the installation version of the CD to remove all the factory partitions and then create a new partition installation system, a key recovery will also damage, if the hard disk has important data must be backed up in advance.
If you install the system, after you delete all partitions after the new partition to install the system will not start normally, card in the Windows 7 login interface, this is generally due to the factory pre-installed system is GPT partition mode is not normal conversion to MBR mode caused by
If you are installing a Windows XP system, you need to debug the BIOS in the following ways.
Modify the hard drive mode to change the "AHCI" mode to "compatible" or "IDE" mode
1. Go to "BIOS", select "SATA Controller mode" in "Configruation", change "AHCI" mode to "compatible" mode, then install XP system normally. The following figure:
2. Select the optical drive or U disk boot installation, before the installation interface appears if "PressF6 if you need to install ..." prompts, you need to press a few "F7" button, and then the normal installation of XP system can be.