Detailed description of the IP bandwidth control function in the Broadband Router

The IP bandwidth control function in a Broadband Router is very important. Its main function is to rationally allocate bandwidth and make vro configuration more flexible. The use of a Broadband Router saves us bandwidth costs, but because it is a shared environment, under the same line, someone is downloading movies from the Internet at high speed, his neighbors cannot even open the webpage.

The unfair bandwidth allocation has plagued many people. How can we make reasonable and fair use of bandwidth? Some SOHO broadband routers in TP-LINK have upgraded the "IP bandwidth control function" to provide a variety of bandwidth allocation schemes and flexible configuration, which is very practical for the multi-user shared broadband environment. Next we will briefly introduce how to configure and use the IP bandwidth control function.

1. After the upgrade, log on to the Broadband Router management interface and you can see the IP bandwidth control menu on the left. Here you can set different modes and bandwidth sizes for different users' IP addresses.

2. First, select the Enable IP bandwidth control option above, and then you can set it in detail. When selecting the bandwidth line type and specifying the bandwidth size, please select and fill in according to the bandwidth service you actually applied for. If you are not clear, please consult your bandwidth provider, such as China Telecom or China Netcom ). For example, if you are applying for China Telecom 2 m adsl, You need to select the line type "ADSL" and enter the bandwidth size in 2000.

3. Configuration Guide:
Recommended minimum guaranteed bandwidth Scheme): the total bandwidth of the IP address or IP address segment restricted by this rule can reach at least this value, and the maximum is unlimited. This mode maximizes the use of Bandwidth Resources. The bandwidth is generally set to total bandwidth/number of computers. Assume that there are four PCs on the 2 m adsl line, the bandwidth available for each computer is 2000/4 = 500 K. This mode allows computers to obtain at least KB of bandwidth when the line is busy, reflecting the principle of fairness. bandwidth can be fully utilized when the line is idle, reflecting a reasonable principle.

The maximum bandwidth limit is a simple solution): the total bandwidth of the IP addresses or IP address segments restricted by this rule can only reach this value. This mode can effectively and quickly limit the bandwidth used by individual Intranet users such as BT and thunder. The so-called "one-click throat seal" can immediately control the download speed. If it is found that the BT download is enabled by Li Si, it affects the use of other users. You can set this entry: The maximum bandwidth of 192.168.1.11 is 500 Kbps. After the configuration, the sub-devices of Li Si cannot exceed 500 Kbps when the bandwidth is sufficient. 3) set;

Note:
1. Each of the preceding entries sets an IP address. Generally, do not set it to an IP address segment.
2. After the bandwidth control function is upgraded, if the bandwidth control function is still upgraded, disable the bandwidth control function before upgrading the bandwidth control function.