Detailed illustration: D-link router VPN settings

In fact, the VPN settings of the D-link router are very similar to those of other route VPN settings. Next we will explain the configuration steps of using the DLINK router to establish a point-to-point VPN, in the following article, we will take the most common method of static IP addresses at both ends as an example to describe the Setting Process of 804HV. The configurations of vrouters of other DLINK models are similar.

Experiment environment: Two 804HV instances are connected to the same CIDR Block through a vswitch, and each of them is connected to a PC as the client device under 804HV. The Wan address of one 804HV instance is 172.18.193.10/24, the Intranet address is 192.168.0.0/24, the Wan address of the other 804HV is 804HV-B) is 172.18.193.20/24, and the Intranet segment is 192.168.1.0/24.

D-link router VPN settings 1. Set the wan connection mode of 804HV to static address mode

D-link router VPN Settings 2. Create a VPN tunnel and configure automatic negotiation and encryption parameters

Click more in "Method" to enter more detailed parameter configuration process.

Click "Select IKE Proposal ..." Enter the parameter configuration:

Note that in the above "DH Group", there can be three options: Group1, Gruop2, and Group3. In some VPN devices, it corresponds to 768bit, 1024bit, and 1536bit. When setting between different products, you must understand the relationship between them.

D-link router VPN settings 3. Configure 804HV804HV-B on the other end in the same way. The configuration interface is shown as follows: