Diagram of the entire netcore vro configuration process

Note the following before configuring a netcore vro:

1. You should first make sure that the broadband has been installed, that is, the computer can directly access the Internet through cat dialing.

2,VroThe installation is correct.

The entire process of netcore vro settings:

1. Open your browser and enter "http: // 192.168.1.1" in the address bar"

2. on the pop-up page, enter the username: guest and password: guest. Click "OK.

The default username and password used for netcore vro configuration are "guest". If any error occurs, see the instruction manual or the vro backend label.

3. After logging in, click "Wizard" in the upper right corner.

4. Click Start in the pop-up window.

5. In the displayed window, select "PPPoE" and click "Next.

6. In the pop-up window, enter the user name and password provided to you on the ISP service, that is, your broadband Internet access account and password. Click "Next. 7. If the pop-up window prompts whether to allow Windows to save the password, select "no ".

8. netcore vro configuration is complete.