Disable Automatic ipv4 Address Configuration for win7 and disable win7ipv4
Symptom
A new computer is connected to a network cable without dhcp. You need to manually configure the Ip address.
After an Ip address is configured, the ping gateway fails.
Two IP addresses are found in ipconfig:
Automatically configure the IPv4 address .......: 169.254.11.19 (preferred) subnet mask ............: 255.255.0.0 IPv4 address ............: 172.16.1.11 (copy) subnet mask ............: 255.255.255.0
The automatically configured 169.254.11.19 is preferred for analysis, so it is not connected to the gateway. However, the NIC is a manually configured IP address and automatic configuration is not enabled.
The IP address may conflict.
Solution
Manually change the IP address to 172.16.1.202. The Gateway is successfully pinged.
How can I disable automatic configuration of ipv4 address 16925414oo in win7?
192.168.0.0? Or 0.0?
How to disable automatic configuration of IPV4 address 169254 in WIN7
If you set an IP address and check IPCONFIG, the IPV4 address is always automatically configured. It should be because the local ip address you set conflicts with the IP address set by someone in the LAN, you just need to reset a new IP address. I tried it for one morning and found this problem !!!