1. Open the Control Panel and double-click the small orange horn to run, as shown in figure:
2. Open HD sound card Control Panel, select "Mixer".
3. Go to the "Mixer" option and check the "microphone volume" in the "Record" bar. If you do not see the "CD volume, Microphone volume, line volume, stereo Mix" in the recording settings at this time, click on the small wrench in the lower left corner of the "recording" in the image, and then click the "Enable multiple-channel recording" Tick to click the OK button.
After the above step, and then the following figure, on the right select "Realtek hdaprimary input", there will be "CD volume, Microphone volume, line volume, stereo Mix" these four.
4. Check the microphone volume in the record bar and adjust the volume to the maximum, which is the maximum recording volume.
5. The top of the playback knob in the small red dot, also pull to the + side, and then the right waveform, software synthesizer, and all the volume is adjusted to the maximum, as shown in the figure.
6. Then click on the right side of the small arrow, turn the page, and set all the volume of the items to pull to the top for the most amount. As shown in the picture (shown in the red box)
7. After turning the page, appears as shown in the following figure, in the "Front mic" and "microphone volume" in the general is not to go, only very few software and motherboards need to be removed, after the removal may have a buzzing murmur, this according to the individual machine settings, here does not require.
8. After this step, click OK below to make it save.
9. Switch to the audio I/O panel and click the Tool button on the right side of the simulation.
10. The following dialog box appears, with the check "Disable front panel jack detection" (default no hook), save exit, you can realize the HD Audio front microphone recording.
11. Finally switch to the "microphone" channel, the default setting is invalid, we change to "Realtek HDA Primary input" as shown in the figure.
12. Then one last click on the following OK.
13. If the above settings are not valid, check to see if the microphone is muted (partially with a switch) or is damaged. The following illustration provides an example of whether the microphone is muted in the system.