Dynamipsgui Small van simulator vpcs DHCP function

Dynamipsgui VPCS version is relatively low, there is no DHCP function, which is very inconvenient for us to do experiments at ordinary times.

Cold blog here with the small where the simulator, with 0.13 of the vpcs.

Take the Windows XP platform for example, the cold blog teaches you how to upgrade your existing vpcs, and because of the different emulator versions, it is recommended that you back up the original program first.

First go to the official website to download the new version of VPCS, but recommend 0.15a version, because this is the first edition with DHCP function VPCS, and high version such as 0.2X does not support small where the configuration file startup.vpc some commands.

Is that the new version of the command has changed, cannot be compatible with the existing versions of the small van Dynamipsgui simulator.

1. Download:

Http://www.freecode.com.cn/lib/exe/fetch.php?media=wiki:vpcs-0.15a.zip

2. Upgrade:

In the small any installation directory, empty the VPCS directory, the new version of the content to vpcs directory.

Deletes the startup.vpc file.

The cygwin1.dll file in the compressed package is overwritten with a file of the same name under the installation directory.

Do a random experiment, run VPCS.exe

If it appears: Welcome to Virtual PC Simulator for dynamips, v0.15a

Indicates that the upgrade was successful.

VPCS 1?

Show Print The net configuration of PCs.

D Switch to the pc[d], d are digit, range 1 to 9.

hist List The history command, use arrow keys to get

recently-executed commands.

IP address CIDR [gateway] Set the host ' s IP, gateway ' s IP and network mask.

In the ether mode, the IP of the TAPX is the

Maximum host ID of the subnet. Default CIDR is

' IP 10.1.1.70 10.1.1.65 ', set the host IP

To 10.1.1.70, the gateway IP to 10.1.1.65, the

Netmask to 255.255.255.192, the TAPX IP to

10.1.1.126 (ether mode).

DHCP Configure host/gateway address using DHCP.

ARP show arp table.

Ping address ping the network host.

echo address port [UDP|TCP] echo the host port with protocol (UDP/TCP).

tracert address [Maxhops] Print the route packets take to network host.

Default Maxhops is 64.

conf [Lport|rport] Port Set local or remote port. ' Conf lport ' would close

The old port and open the new port. Only UDP mode.

? Print Help.

Quit Close all port (UDP mode) or the TAPX (ether

mode), then quit.

Do you remember Mr Mike Muuss?

This article from the "Operation and maintenance work Struggle" blog, please be sure to retain this source http://yanghuawu.blog.51cto.com/2638960/827957