Unconsciously has entered the junior school, this semester may be the most specialized courses in the University of a semester, to the senior may have no lessons to go on. So in the spirit of cherish the present time, learn every lesson of the idea, began the mechanical and electrical transmission control of learning.
The first Zhou gang, I understand this course is to study motor control and transmission. Now electromechanical control drive is a new type of Transmission control mode. That is, each moving part has a motor drive, which greatly reduces the original motive and the drive between the machine design requirements, the number of traditional mechanical parts and design difficulty greatly reduced, which is also a trend of modern mechanical design.
Browse the teacher's class material "Introduction to equipment manufacturing and automation integration", mainly introduces the problems faced by machinery manufacturing, development trends, design points and other aspects of the content. Talking about the current manufacturing automation, intelligent is the inevitable trend of manufacturing, which is the electromechanical integration plays an important role, and the future of mechanical manufacturing will pay more attention to energy efficiency and personalization, so also for the future of Mechanical engineers put forward higher requirements. Now our expertise is still in the accumulation stage, but the existing knowledge has been able to make some simple mechanical products, but from the design to the end of the distance between the finished product is quite large, so we need to pay more attention to practical training, more participation in some competitions, training themselves as a mechanical engineer of all aspects of quality, Not only professional knowledge, but also team work, mechanical design standards, familiar with the norms and so on.
The last simple to browse the textbook, there is no time to look carefully, the second chapter is the physical dynamics of the Foundation, the third is the physics of the motor (electricity and magnetism), the basic theory is very simple, just a period of time useless, may be some details are not too clear, but the difficulty is not very small. Now, the difficulty of this course should still be in the back part. The teacher gave the modeling software has not had time to use, this part will stay until later to understand.
Electromechanical Drive Control 1