Experimental three-experiment report 20135219 Hong Wu 20135201 Li Chenxi

Beijing Institute of Electronic Technology (BESTI)

Real Inspection report

Course: Information Security system Design Basic class: 1352

Name: Hong Wu Li Chenxi

Study No.: 20135219 20135201

Score: Instructor: Lou Jia Peng Experimental Date: 2015.12.8

Experiment level: Preview degree: Experiment time: 15:30~17:30

Instrument Group: Compulsory/Elective: compulsory test number: 03

Experiment Name: Experiment Three

Experimental purposes and requirements:

1. Learn the principle of driving design under Linux;

2. Master the process of driving development and debugging by using the module method.

Experimental instrument:

Name	Model	Number
Embedded experimental Platform	Up-tech s2410/p270	1
PC Machine		1

experimental purposes and requirements :

Objective: 1. The installation of real-time software according to the experiment Instruction book.

2. Try to configure the lab environment and learn to test the software.

Requirements: 3. Correct use of the cable and other experimental equipment, and pay attention to the protection of the Experimental chamber. The lab is sent back after the experiment is over.  

First, the experimental steps

1.0 Connect the Experimental box power, use serial line, line, network cable, connect the experiment box and the host

1.1 Install Ads (install files in 00-ads1.2 directory, crack method 00-ads1.2\crack directory)
1.2 Installing the Giveio driver (installation files in the 01-giveio directory)
Copy the entire Giveio directory to the C:\WINDOWS and copy the Giveio.sys file under the directory to c:/windows/system32/drivers.
In the Control Panel, choose Add Hardware > Next > select-yes i have connected this hardware > Next > Check-Add New Hardware Device > Next > Check Install I manually select from list

Hardware > Next > select-Show All devices > select-Install from disk-browse, specify drive as C:\WINDOWS\GIVEIO\giveio.inf file, click OK, install driver

1.3 Installing the JTAG driver (install files in the 02-uarmjtag2.0 directory)

1.4 Configure HyperTerminal: Baud rate is 115200, data bit 8, no parity, stop bit 1, no data flow control.
1.5 Test the basic installation is correct, refer to document "03-Test document. pdf", test program in 04-test directory

1.6 Run the ADS1.2 Integrated development environment (in start-programs-in). Open the EXP11.MCP file in File-open-exp3-04-test order.

1.7 Select the Src,lib,startup,init file in the file list and click Make in the top toolbar to compile the link.  

1.8 Be sure to turn on Uarmjtag Click Initialize configuration option before running the debugger ARM9 click OK. Minimize to the pallet and ensure our platform stops in the Vivi state.

1.9. Click the Debug button to debug the simulation, and the debug interface is displayed. This is to jump out of the warning, ask teacher teacher said is a hardware problem.

Two. Experimental experience

The experiment did not finish it took three weeks, the beginning of the test document garbled, ask the teacher, the teacher let the computer and board. But repeated seven or eight times or garbled, and finally inadvertently, then jumped out of the warning, the teacher said is a hardware problem, let us pack things away. We had spent three afternoons in this experiment but didn't learn anything and felt sorry.

Experimental three-experiment report 20135219 Hong Wu 20135201 Li Chenxi