FAQ of UPA USB New V1.3.0.14 with full adaptors

Wobd2.com have released a new version of UPA USB Programmer:upa USB V1.3.0.14 with full adaptors,updated script Exampl E files,added script function autobaudratedevice (HC08 devices only), UPA USB are with software V1.3.0.14 and support E Nglish Language.
Following is the pictures Display:

FAQ:
Q:
had UPA USB v1.3 from WOBD2 and the adapter board that read 95160 had pins were to co Nnect the clip wire but the clip was not included, I had ordered one from Wobd2 now, since the solder place for 95160 on T He adapter I defect and I hope it also works with clip to read and to write, I had de-soldered the EEPROM. My question: Can The Soic8 clip is used with UPA USB programmer for reading EEPROM chip st95160 and for writing th E eeprom?
A:
Normally you can use clip to Read/write EEPROM with UPA USB programmer, but sometimes is absolutely necessary De-solder EEPROM from the PCB to read it. Always be better desolder EEPROM for garanted 100% read OK. Anyway if you decide use clip, remember verify dump after read it's or three times and check the read dump with hex edit Or for guaranteed the most possible, the dump is OK.

Q:
Why is the UPA USB Programmer with full adaptors asked for activate?
A:
New Upa-usb is the full set with all adapters. The main Device can be directly connected to the Elrasoft.com uusp (Upa-usb Serial Programmer) or by an optional DB9 male/ Female.

Q:
How to activate UPA USB Programmer?
A:
You need to copy the crack file to the installation Directory under C driver. Then open the UPA USB software and fill any data as you want. The problem would be solved.

FAQ of UPA USB New V1.3.0.14 with full adaptors