Fatal error link 1104: Unable to open the file "cvcore. lib.

Run the program as planned this morning to see how it works! The result is compiled and cannot be passed during the link. A. Lib file cannot be found. So I sent the error message to the railway network and was about to search it. It's strange to say that none of the web pages have such records. At that time, I was wondering if I had encountered special problems? So I reduced the search content and searched for "cvcore. lib". I did not expect this, but I found a lot of web pages. So I was pleasantly surprised to open a webpage one by one to see if there is any solution. The results were disappointing, but they all raised questions. There was no solution to the problem.

I continued to be patient and ran to the group to ask everyone, but there was a response. An enthusiastic netizen analyzed it together and I operated it step by step here. The result was the same. Later, the user sent the code, but he was not online again. So I went on to look for it.

At this time, another lab student came over and asked him about it. He doesn't know much about opencv, but he is quite familiar with vc2008. While explaining opencv to him, he began to clarify his ideas. After 12 o'clock, the problem still persists, so I went to dinner.

In the afternoon in the dormitory, I want to see if it is a problem with the environment. So I ran it on my computer in version 1.0 and it was actually ready to run. The result is displayed, and the effect is good.

Just think that you can get the result, and let him go with lab errors! I went to the library to read a book in the afternoon, but my heart was so uneasy that I chose to come to the lab and thought I had to solve this problem.

At this time, the enthusiastic netizen gave me a message and the Code on his side can run. So I am sure the problem lies in the configuration of the vc2008 environment, and the user prompts me whether the environment variables are set correctly. When I started it, there was still a problem. I wrote "vc2008" as "vs2008", and I had a bit of happiness in my mind. It was estimated that after the change, I would be able to run normally. However, after the instance is shut down and restarted, it still cannot run.

Later, I discovered that the problem should not be here. Because the file in debug has been copied.

So I used the last method and re-installed opencv. It takes more than half an hour. We are looking forward to handling the problem, but the result will not work.

When I was excited, I suddenly saw the error prompt "cannot open the file:" cvcore. lib "". There is a flash in my mind. Is there a cvcore. Lib library? Aren't all cxcore. Lib libraries? Finally, I found the crux of the problem!

I faint!

Summary:

1. Be careful later, especially in some details.

2. Strengthen your thinking. In retrospect, similar messages cannot be found on the Internet, which may indicate some problems. Haha, but this time I became the first person!

3. Do not reinstall the software easily. Because of some problems, it is useless to reinstall it once you do not understand it! The problem persists!