If you forget the password to enter the CMOS Setup program, in addition to using the jumper short removal method on the motherboard, you can also use the method of software removal, this article has sorted out the five methods of eliminating the CMOS password under DOS.
Open the chassis, locate the battery on the motherboard, disconnect it from the motherboard (that is, remove the battery), and the CMOS will lose all information stored internally because of power loss. Then put the battery on, close the chassis on, because the CMOS is a blank, it will no longer require you to enter the password, this time into the BIOS Setup program, select the main Menu "load BIOS default" (Load BIOS defaults) or "Load SETUP default" ( Load Setup defaults, the former starts the computer in the safest way, which enables your computer to perform a higher performance.
Magical Debug Erase CMOS password
If you forget your password to enter the CMOS Setup program, you can use the software removal method in addition to using the jumper short removal method on the motherboard, and here's how to clear the CMOS password in DOS.
An editor in DOS, which is DEBUG, is a very useful tool to start by typing a command at a DOS command prompt: Debug, and then go to the debug editing interface.
After you enter a command in the command state, restart the computer to clear the CMOS password, and five command lines to clear the CMOS password are given below.
Method One
-O 70 16
-O 71 16
-Q
Method Two
-O 70 11
-O-FF
-Q
Method Three
-O 70 10
-O 71 10
-Q
Method Four
-O 70 23
-O 71 34
-Q
Method Five
-O 70 10
-O-FF
-Q
Method Six
-O 70 90
-O 71 91
-Q