ASUS S550 Series Notebook How to dismantle the machine to clear ash?

ASUS S550 Series Notebook How to dismantle the machine ash? Notebook computer for a long time will have a lot of dust, Asus notebook ash than the general cleaning of the notebook is much more difficult, even to clean up the dust on the fan, you need to remove all the parts to clean up, Below to share the ASUS S550 Series Demolition Machine Clear the detailed graphics tutorial, need friends can refer to the next.

1, the fuselage back facing up, first remove the battery.

2. Use a screwdriver to remove all the visible screws on the back, take care to put the removed screws in place, preferably in a small box, to avoid loss.

3, the fuselage in front of the board has two screws, removed after the board to slide forward to remove, you can see the hard disk, memory and another memory socket and the audio line. Remove all visible screws, remove the hard drive and unplug the audio cable from the socket. (Note that before touching the hard drive, you should put the static on your hands clean, the simplest way is to touch the ground or wall with ten fingers)

4, at this time may be under the CD-ROM fixed screws, this screw in the middle of the panel, there is a black rubber cover, you can directly peel off the rubber, remove the CD-ROM fixed screws.

5, the fixed screw is removed, the optical drive is pulled out, at this time there is no screw on the back cover, with a skid plate or a flat screwdriver along the edge can be directly pry up the back cover, the back cover and the motherboard only connected to the only audio cable, must be careful not to rip off! (Although all are S550 series of computers, but there may be different models, the number of lines are different, you must take care when removing the rear cover to not break the line)

6, remove the back cover, the dust on top of a lot.

7, the motherboard can see the cooling system.

8, to remove the screws, pay attention to the two-circle, there is a square of rubber cover a screw, this piece of glue can be taken directly down. Pay attention to the power cord of the fan and unplug it before removing the fan, lest it be torn off.

9, take down, the cooling fan above has 10,000 kilograms of dust, their own ash swept away on the line, it is worth noting that the fan and the heat of the copper pipe between the connection is not very close, you can use tweezers to wipe the dust above the wet paper.

10, after cleaning up, it is best to add lubricating oil to the fan, there is a dedicated lubricant best, no words lard is also very good, and the best to the CPU and graphics card to replace the new thermal silica gel, and finally everything will be put back on the finished.

Precautions:

1, do not break line.

2, touch the inside of the chip motherboard what to put on the hands of static electricity clean.

3. There is a risk of dismantling the machine. In the event of accidental liability.