BIOS Best tuning settings

How to enter the BIOS

Generally in the computer startup when there are English tips, you can not grasp to grasp, if too fast to grasp, not to use the following methods:

1, enter the notebook computer BIOS method collection: Ibm-f1 key, HP, SONY, DELL, Acer, Fujistu and so on most-f2 key, toshiba-first ESC after F1 key, Campaq-f10 key.

2, into the desktop computer BIOS method collection: Generally there are two ways, most of the startup when the Del Key, and some version is pressed F1 key (such as award, AMI), and the other is to start the press Ctrl+alt+esc key combination. There are also a few other ways to enter, such as Phoenix Press F2 key, Campaq machine is pressed F10 key.

BIOS Best tuning settings

The type and mode of a port that does not have an IDE device attached to the standard CMOS setup is set to none.

2. Set the CPU Internal cache, External cache to Enabled, and turn on the CPU level one or two cache.

3. Set the system Boot up speed to high. Make the system boot at high speed.

4, set the boot sequence to c,a:.

5. Set Floopy drive Seek at boot to disable. Causes the floppy drive to not be detected at startup.

6. Set the above 1MB Memory test to Disabled. No more than 1MB of memory is detected at startup.

7. Set boot up floppy seek to disabled. Doing so will not allow the floppy drive to seek operations at startup.

8. Set the video BIOS shadow to Enabled. The BIOS on the video card is mapped to memory for increased display speed.

9. Set the system BIOS shadow to Enabled. Enables the system BIOS to map memory for improved performance.

10. Set the video BIOS cacheable to enable. The BIOS on the video card is mapped to the cache.

11. Set the system BIOS cacheable to enbaled. Map the bios of the motherboard to the cache.

12, set the cache timing to Fastset.

13, the SDRAM CAS Latency time is set to 3. Sets the delay time for SDRAM. If your memory quality is not very good, setting it to 3 will greatly reduce the freezing situation.

14. The BIOS with via Apollo Pro Series Motherboard chip has a "DRAM CLOCK" to change its value to hclk+33, so that your memory will work in the system FSB +33 of the frequency, if your CPU is Celeron, the performance of the system will be very obvious , you can set the value of "DRAM CLOCK" to "HOST CLK (System FSB) or" HOST-33 "If your memory is not in order. This is because the Apollo Pro Series chips have unique memory async technology