Buffalo whr-g300n v2/whr-g301n brush openwrt and subsequent Password reset

Depending on the original hardware, you can use the following methods:

1. If you start with a buffalo firmware brush openwrt, you can directly click the URL:

Http://downloads.openwrt.org/snapshots/trunk/ar71xx/

Under the openwrt-ar71xx-generic-whr-g301n-squashfs-sysup...>

You can simply click this firmware.

2: If tftp is used in windows

First, enable the telnet function:

1. "control panel" 1> "program" 1> "enable or disable the windows function". You can see many service items in it. Select
Select "telnet server" and "telnet Client. In this way, you can return the "service item" or
Services. msc, you can see telnet,
2. Choose "control panel"> "administrative tools"> "services" or "services. msc" to go to the service item list.
Find telnet and you will see that it is disabled. In this case, right-click "disable" and select ""
And change "disabled" to "manual", and then right-click the status bar and choose "start ". This way
The telnet service on your machine is started.

Enable OpenWrt security mode

Power-off.

Press and hold the reset button at the bottom of the router. When the router light starts to flash, the reset is released. If you press it for a long time, the route continues to start.

In this case, the router light will flash fast and can be accessed via 192.168.1.1 via telnet.

(OpenWrt has a built-in security mode. In this mode, OpenWrt bypasses almost all configurations and uses the built-in default configuration, the route will start only necessary services and use the default IP address 192.168.1.1/24. in this case, you can use telnet to connect to the route and fix some errors.
Read the Flash Layout and you should understand that the OpenWrt security mode can help you solve any problem because OpenWrt uses the JFFS2 partition to store user data (if you are using SquashFS firmware )! You can use the safe mode to restore your password, firewall, or startup script .)

First, use HFS (HTTP File Server) on the local machine to build a Server and mount the firmware.

Run the following command to fl the firmware:

Wget http: // PC address/firmware name with a suffix (for example, xxxx. bin)
Mtd-e linux-r write firmware name and suffix linux

Example: wget http: // 192.168.1.109/1.bin
Mtd-e linux-r write 1.bin linux

The process for restoring factory settings is as follows:

Power-off.

Press and hold the reset button at the bottom of the router. When the router light starts to flash, the reset is released. If you press it for a long time, the route continues to start.

In this case, the router light will flash fast and can be accessed via 192.168.1.1 via telnet.

Enter telenet to go to its interface.

Then enter firstboot to initialize OK.

 

Buffalo whr-g300n v2/whr-g301n brush openwrt and subsequent Password reset