Q: Does the CorelDRAW Font contour cross issue cause the splash strokes to not be able to carve the output?
In the CorelDRAW input text ding Word, add and bold contour line after the outline will splash out (that is, the outline will spread very far, very irregular), how to solve this problem?
A: 1, the following coreldraw in this picture, the flying edge word.
2, press F12, set as follows:
Press F12, corner line to select the middle of the round head can be, the following figure. The Transform Contour property is a round head line.
In Wentai and other engraving software, try to avoid these intersecting lines of the font, these fonts are actually non-standard fonts, the proposed use of founder, Chinese and other fonts, text tripod font in 2000 and XP and PS software and some other software will have conflicts. You installed the text tripod font can not install PS software and so on.