Driving test: 600 km examination process and precautions _ Driving test

1. Students on the car after the commissioning seat, assistant examiners operating machine, press the timing training button into the selection of students interface, click on the right side of the right button to apply for a test. Students to the car to show the right camera ticket and identity card waiting for approval examination.
In the process of waiting, one voice prompts "Waiting for approval", such as no voice prompts to explain the wireless signal or weak signal. The vehicle can be moved back and forth. (Note: Students with eyes waiting for approval are best to take their glasses off, pending approval after the examination in the wearing glasses.) Because the photo on the ID card is not wearing glasses. Prevent the driving department from saying that I do not conform. ）
2. After the voice prompts to approve the test, students get out of the car clockwise cover the probe (3 seconds before and after each). After the students get on the bus, fasten their seat belts and turn to the horn to make a start.
3. In the course of the exam, students are required to start the vehicle smoothly. Has 30 seconds speed must reach 40 kilometers above, passes the crosswalk, the bus station, the intersection speed cannot exceed 30 kilometers.
4. In the examination process voice prompts: (The front changes the lane area) must hit the turn the light or left or right can, after the return is turning the light switch.
5. When the end point, Voice prompts: Please pull over, students stop after the air, pull up the parking brake (pull up the parking brake when the feet do not leave the brake pedal) after the students do not wait for voice prompts: Test finished, data upload success in the loose seat belt off.
6. Before applying for the examination, the assistant examiners should check if the light on the door of the car is lit (if not, please put the switch on the door to open the position, on the contrary, the students will prompt the car door ajar examination unqualified).
7. Night road examination should indicate that students can not use the remote light, the examination process of the long light light began as a test unqualified.

The first stage: 0 to 50 km. The contents of the test are: getting ready for the car, starting a straight line, adding and reducing gear, honking, emergency braking, pulling over. Small-class vehicles should be driven at speeds below 60 km/h, exceeding the specified speed regardless of mileage.
The second stage: 50 to 500 km. The contents of the test are: getting ready for the car, starting a straight line, adding and reducing the position, changing lanes, pulling over, crossing the road, turning left, turning right, crossing the crosswalk, passing through the school area, passing through the bus stop, passing, overtaking, and driving at night. The vehicle speed should be below 60 km/h, the average speed is measured once every 10 minutes, for a record period, all valid record cycle reaches the standard mileage, this stage ends.
The third stage: 500 km to 600 km. The contents of the test are: getting ready for the car; starting; running straight; add and subtract position operation; change lanes; Take the driveway, pull over, go straight through a junction, turn left, turn right, pass a crosswalk, pass a school area, pass a bus stop; passing; overtake; turn around; continuous driving test for two times; , starting point should be inconsistent; only one continuous driving test can be conducted daily. The speed of the vehicle should be below 60 km/h, exceeding the specified speed. Vehicle continuous driving speed should be less than 60 km/h, continuous driving test results are not qualified, can not apply for appointment to three exams, need to restart continuous driving test until the requirements.
The test content of Phase IV is: getting ready for boarding; driving straight, adding and reducing the position, changing lanes, taking the driveway, pulling over, crossing the road, turning left, turning right, crossing the crosswalk, passing through the school area, passing through the bus station, passing, overtaking, turn around, and when the third phase of continuous driving is unqualified, Please refer to the third stage of continuous driving test requirements to complement continuous driving. Continuous driving is qualified, only the insufficient number of kilometers to make up.

From:http://www.sytdt.com/html/classrooms/2011-5-6/57.html