HP HP DL160 G6 RAID and Server2003 system installation method

HP HP DL160 G6 RAID and Server2003 system installation method

HP ProLiant DL160 G6 Server

Manually install the Windows Server 2003 system and manually install all drivers

(Pictures from Xin Pengcheng)

Hardware environment: DL160G6

Software Environment: Windows Server 2003 SP2

Array card: HP Smart Array b110i SATA RAID Controller

Other equipment: U disk

Operation Steps:

1. If you need an integrated array card to do the array, first F10 into the BIOS, the Advanced-sata configuration sata#1 Controller mode option to open the integrated array card b110i array features, selected as RAID.

2. Under the boot option in the BIOS, set the integrated b110i array card as the lead boot entry 1st Drive.

3. Direct with Win2003 system disk boot, if configured array, then the screen will have F6 prompts, need to use U disk load Integrated b110i motherboard integrated array card driver; otherwise skip directly, in this main introduction system installation steps: http:// H20565.www2.hp.com/portal/site/hpsc/template. Page/public/psi/swdhome/?sp4ts.oid=3884344&spf_p.tpst=swdmain&spf_p.prp_swdmain=wsrp-navigationalstate %3dswenvoid%253d1113%257cswlang%253d%257caction%253dlistdriver&

Javax.portlet.begcachetok=com.vignette.cachetoken&javax.portlet.endcachetok=com.vignette.cachetoken

4. You will first be prompted to press C to create a disk partition on the unpartitioned disk space to install the system:

5. This experiment only divided into a C area, of course, the number of partitions and partition capacity of customers according to their own actual distribution, personal recommendations C disk capacity preferably greater than 10GB; After you create the partition, select the partition where you want to install the system and click Enter to start installing the system:

6. Select File system type, this test select the NTFS (FAST) file system format, and press ENTER to start formatting the hard drive: