Learn how to configure a Message Server in WebLogic Server

1. Start the WebLogic Server and open the Weblogic console by usingHttp: // localhost: 7001/consoleOpen, 1-1; enter the user name and password to enter the Weblogic management interface, 1-2.

Figure 1-1

Figure 1-2

2. Click "service | message passing | JMS server". The "new" tab is displayed on the right side, 2-1. Click this tab to create the JMS servers. The interface shown in 2-2 is displayed.

Click "Next" to go to the page shown in Figure 2-3. Select adminserver and click "finish" to create the JMS server. 2-4 displays the created JMS server.

Figure 2-1

Figure 2-2

Figure 2-3

 

Figure 2-4

3. Configure JMS modules. Click "service | message transmission | JMS module", and the "new" tab appears on the right. Click it to create a JMS module, as shown in Figure 3-1.

Click "Next" to go to the 3-2 page. Select the "target" server as "adminserver ".

Figure 3-1

Figure 3-2

Click "Next" to go to Figure 3-3. Select "do you want to add resources to this JMS system module ?" Click "finish" to go to Figure 3-4, indicating that the module is successfully created.

Figure 3-3

Figure 3-4

4. Create resources. Click "new" to go to Figure 4-1. Select a queue and click "Next" to go to Figure 4-2. Set the JNDI nameJMS/mymdb.

Note: The JNDI name must be consistent with the message objective in the message-driven bean code and the message objective of the message sender.

Figure 4-1

Figure 4-2

Click "Next" to go to Figure 4-3. Click Create Sub-deployment to go to Figure 4-4. Click OK to go to Figure 4-5 and select a JMSServer-0. Click Finish to return to Figure 4-6.

Figure 4-3

Figure 4-4

Figure 4-5

Figure 4-6

5. Create a "connection factory ". Click new to go to Figure 5-1. Select "connection factory ". Click "Next" to go to Figure 5-2. Enter the connection factory's JNDI Name:JMS/mymdb-factory.

Note: The JNDI name here must be the same as the name of the message factory used in the previous message sending program.

Figure 5-1

Figure 5-2

Click "Next" to go to Figure 5-3. The server adminserver has been selected. Keep the default settings. Click Finish to go to Figure 5-4. It shows the resources in the created JMS module,

Includes a connection factory and a queue.

Figure 5-3

Figure 5-4

6. view the JNDI tree. For more information, see learning to view the JNDI tree diagram in weblogic.

The JNDI tree is shown in 6-1:

Figure 6-1