Mount 2T New Hard Drive

Cause: After formatting with fdisk partition, Mount Discovery reads only hundreds of MB of space, which is larger than 2T to use parted format to GPT partition.

Solve:

1. Use the fdisk-l command and LSBLK to view disk information (/DEV/SDC)

2. Installing parted

# Yum Install parted

3. Partitioning

① You can enter p to print disk information, view the partition, and find the start and end locations

# PARTED/DEV/SDC

② Setting the partition type to GPT

# Mklabel GPT

③ primary refers to the partition type as the primary partition, 0 is the start of the partition, and 100% is the end of the partition. The same command is: Mkpart primary 0-1 or Yes: Mkpart primary 0 xxx End of space

# Mkpart Primary 0% 100%

④ Print the current partition to see if the partition settings are correct

# Print

quit with quit after ⑤ completed

# quit

4. format the disk, if supported EXT4 selectable format to EXT4

# MKFS.EXT3/DEV/SDC1

5. mount to the/SANDIB2B directory

# mkdir/sandib2b# MOUNT/DEV/SDC1/SANDIB2B

6. Set Restart Auto Mount partition

# Vi/etc/fstab Add a line:/dev/sdc1/sandib2b ext3 defaults 1 2

This article is from the "Freedom Trail" blog, be sure to keep this source http://wangy8961.blog.51cto.com/10174968/1640915

Mount 2T New Hard Drive