PPPoE Server configuration commands and procedures

In some previous articles, although we have introduced some PPPoE Server configuration methods, they are all based on window operations. Here we will explain in detail the text command PPPoE Server configuration method, in general, our configuration can be divided into four steps.

The configuration of the PPPoE Server of RouterOs can be divided into four steps:

· Set an intranet IP address pool for PPPoE virtual dial-up users to dynamically allocate IP addresses to customers.

· Add a PPP profile and set an intranet IP address so that the customer can obtain the IP address from the address pool.

· Add PPPoE dial-up users. Users can use their usernames and passwords to dial up.

· Add a PPPoE Server.

After the work is completed, the user can perform virtual dialing

Let's take a look at the specific PPPoE Server configuration operations:

1. Add an address pool named mypool

[Admin @ MikroTik] ip pool> add name = mypool ranges = 192.168.0.2-192.168.0.254

You can run the print command to check whether:

[Admin @ MikroTik] ip pool> print

# NAME RANGES

0 mypool 192.168.0.2-192.168.0.254

2. Add a PPP Profile named myserver

[Admin @ MikroTik] ppp profile> add name = myserver local-address = 192.168.0.1 remote-address = mypool

You can run the print command to check whether:

[Admin @ MikroTik] ppp profile> print

Flags: *-default

1 name = "myserver" local-address = 192.168.0.1 remote-address = mypool session-timeout = 0 s idle-timeout = 0 s

Use-compression = no use-vj-compression = no use-encryption = no require-encryption = no only-one = no

Change-tcp-mss = yes tx-bit-rate = 0 rx-bit-rate = 0 incoming-filter = "" outgoing-filter = "" dns-server = ""

Wins-server = ""

3. Add the user name abc and password 111 For the PPPoE Server. This user can only use the PPPoE service.

[Admin @ MikroTik] ppp secret> add name = abc password = 111 service = pppoe profile = myserver

Run the print command to check whether:

[Admin @ MikroTik] ppp secret> print

Flags: X-disabled

# Name service caller-id password profile remote-ADDRESS

0 abc pppoe 111 myserver 0.0.0.0

4. Add a PPPoE service named mypppoe and set the port to the Intranet interface et22.

[Admin @ MikroTik] interface pppoe-server> add service-name = mypppoe interface = ether2-default-profile = myserver

You can also run the print command to check the configuration.

◆ Configure NAT

Because we use private IP addresses on the Intranet, We need to configure NAT for address translation to make the Internet accessible.

We want to use the RouterOs method called "Source NAT.

[Admin @ MikroTik] ip firewall src-nat> add action = masquerade out-interface = ether1

Use commands to activate NAT

[Admin @ MikroTik] ip firewall src-nat> enable 0

◆ Configure the default route. The IP address 222.169.252 is the next hop address.

[Admin @ MikroTik] ip route> add dst-address = 0.0.0.0/0 gateway = 222.169.252

◆ Configure the client

You only need to install PPPoE virtual dialing software on the client.

Note: the client and server can communicate normally only through the network set connection of the switch device.