Switch command 2-Huawei
20. to configure a switch as a command switch of a cluster, you must first assign an IP address to the management interface and then use the following command:
Switch (config) # cluster enable cluster-name
21. To delete a VLAN from a relay link, run the following command:
Switch (enable) clear trunk module/port vlan-range
22. Use show vtp domain to display the VTP Parameters of the management domain.
23. Use show vtp statistics to display the VTP Parameters of the management domain.
24. The command to define TrBRF on a Catalyst Switch is as follows:
Switch (enable) set vlan-name [name] type trbrf bridge-num [stp {ieee | ibm}]
25. The command to define TrCRF on a Catalyst Switch is as follows:
Switch (enable) set vlan-num [name] type trcrf
{Ring hex-ring-num | decring decimal-ring-num} parent vlan-num
26. After creating a TrBRF VLAN, you can allocate a switch port to it. For Ethernet Switching, you can use the following command to allocate a port to the VLAN:
Switch (enable) set vlan-num mod-num/port-num
27. Run the show spantree command to display the STP status of a switch port.
28. To configure an elan les and BUS, run the following command:
ATM (config) # interface atm number. subint multioint
ATM (config-subif) # lane serber-bus ethernet elan-name
29. Configure LECS:
ATM (config) # lane database-name
ATM (lane-config-databade) # name elan1-name server-atm-address les1-nsap-address
ATM (lane-config-databade) # name elan2-name server-atm-address les2-nsap-address
ATM (lane-config-databade) # name...