Tenda routing Bridge Function Introduction

The Tenda routing Bridge Function introduces how to set the Bridge of the Tenda router. Before setting the bridge, we must set the wireless encryption of the router.
1. log onto the tengda vro interface and click the Advanced Settings button in the upper right corner. 2. Go to the Advanced Settings page, click Wireless Settings-Wireless Basic settings, and change the wireless working mode from the default wireless access point to the Bridge Mode. Www.2cto.com
3. If you know the wireless MAC address of the Peer router, you can directly enter the peer wireless MAC address in the ap mac address bar, you can also find the signal of the remote wireless tengda W316R router by scanning, click Enable scanning and select the signal to be scanned, and click OK to automatically add the MAC address of the corresponding wireless signal.

4. After adding a vro, you also need to set the peer tengda router. The two tengda routers can connect to each other after entering the MAC address of the other vro.
The bridge function requires both tengda routers to support this function, and the SSID must be the same as that of the Peer tengda router. The bridge settings of the router are all described, we believe that you will succeed in following the above steps.