cause analysis and solution of Tp-link Wan port status without display
Dial-up Software is a dedicated software provider, verify that access to the correct access mode and then buy the router is not too late, we recommend that users in the use of the router, first run the Dial-up software on the computer, fill in the username and password dialing.
First, observe the Adslmodem on the ADSL led, under normal circumstances, the modem power network cable, LED flashing, network connectivity after the flashing stop turned to long light.
Second, if always flashing does not appear long bright, that adslmodem with the local switch can not sync, may be the configuration process filled in the Internet password is incorrect, it is recommended to re-enter again.
Third, if the problem is still may be Adslmodem enabled routing mode, the need to reset Adslmdoem to bridge mode.
Four, is not bridge, you can connect the computer and modem, and on the computer dialing, after dialing can be connected to the Internet, it means that the modem mode of work for the bridge.
If the user does not reset the bridging mode, refer to the Modem Factory manual or contact with the service provided.
VI, ISP binding the MAC address on the network card to the ADSL line will also be displayed as NULL, you can use the router's MAC address cloning function, the MAC address of the network card to the router's WAN port.
Seven or more of the above three may be excluded, indicating that Adslpppoe dialing is not a problem. Users need to query their own broadband access, because different access mode dial-up software is not the same, although the authentication protocol used is PPPoE, but dial-up will not succeed.
Eight, if the digital TV 10M bandwidth, it is recommended to find a 10/100m adaptive hub, the broadband access line on the hub, and then connect the hub to the router Wan, after such a rate-matching process, dialing problems can be solved.