Vehicle testing-Chery Rui-Yee

a , input data
1.CAN Bus Description: Position, color, speed, bus type
1) Location: OBD 2) Color: 3) Rate: 500k 4) Bus type: HSCAN 5) test time: 2016.7.4

2. Vehicle characteristics
1) Displacement: 1.6L 2) configuration: Without a key to start 3) Transmission: Manual 4) whether the remote control on the response: no response to enter the remote control 5) No engine anti-theft 6) whether there is anti-theft alarm: No

No engine anti-theft, remote lock to start the vehicle, remote lock can not drive.

No need to step on the clutch to start
3. Door-side data, off open and close to activate can data

No
The doors are all closed.
Main door open
Left rear Open
Right rear Open
Right Front Open
Open the trunk.
4. Braking data
Brake Lift Up
Brake, step down.
Just hit on the file to detect if there are any data changes.
On off data
5. Engine speed
Speed linear ratio 4x
Stall, stop updating
Just on off
On power on the data, stepping on the throttle data
Note that the data is normal after hitting d.
On file
Startup success
is starting
Off
6. Speed data attention to the on-file instantaneous data, and some models hit on the file instantaneous will become 0XFF, this data to shield it off
Static
10km
20km
30km

Proportional relationship 0.08x
On power-on data
7. Key action the best data in an ID, if the data is not an ID, consider on with the boot in an ID
Off file
Keyin
ACC file, cannot activate bus
On file
St Gear
If the ON,ACC data is not found below the data on is updated, on close stop update, can be used as on reference data.
8. Remote identification according to the original car remote control instantaneous out of the data, the data changes corresponding instructions for the relevant unlock or lock press.
Remote lock
Remote lock
Lock unlock in the car
Locked lock in the car
9. Lock status Identify the state of the car lock after locking and after the lock change. Also note that there is no change when both on and the door are opened.
Locked lock in the car
Lock unlock in the car
Lock, then hit on.
Lock back door open
9a. Anti-theft data This data indicates whether the car enters the anti-theft state, also as the lock status of the cue data.
After the remote lock
After the remote lock
Lock the remote and hit the on file.
Remote Lock door Open
10. Clutch signal only manual vehicles require this data
Clutch Lift Up
Clutch step down

On off
11. Light data light data to be updated in the off, and can bus stop to activate before the line, encountered the original car remote control can turn off the headlights, but we do not switch off the headlights of the case need to use.
Light off
Small light on
Headlight Open
12. Gear position (not normally used)
P
In the Rail
R
N
D
M
13. Handbrake signal (usually not used)
The handbrake is lifted and activated only on
Hand brake down.

14. Current Test and other conditions

Second, output data

1. Do I need on power on the output of the window?
2. Down-Window output
Unlock output at 3.ON
Lock output at 4.ON
Unlock output at 5.OFF
Lock output at 6.OFF
7.OFF at the moment after the lock two minutes, whether it can unlock into the security state can unlock?
8. Trunk Output
9. Door side output of main door
10. Steering Light output
11. Speaker output

Vehicle testing-Chery Rui Qi