VMWare Virtual Machine Network configuration

VMWare Virtual Machine network configuration

virtual machine Three ways of networking:Bridge Connection

If you choose to Bridge, it uses the host host's real NIC to interact with the current host.

Just set the IP setting to the address of the same network segment as the host.

This method not only communicates with the host host, but also with other hosts on the same network segment.

Set the system IP in the virtual machine to the host host in the same network segment.

Set the virtual machine's gateway to the physical IP address of the Cheng host

NAT

It uses the VMnet8 fake NIC to communicate with the host. Access to the Internet. Set the system IP in the virtual machine to the same network segment as the VMNET8.

host-only

It uses a VMnet1 fake NIC to communicate with the host. It only communicates with the real machine and cannot access the Internet. Configure the system IP in the virtual machine with the VMNET1 in the same network segment.

This article is from "Worry-free" blog, please be sure to keep this source http://dezewuyou.blog.51cto.com/2628602/1790286

VMWare virtual Machine Network configuration