What about the iphone screen failure solution for iphone screen failure

There are many ways to solve the iphone screen failure:

1, the lock screen state long press the home key to enable voice control, and then said "play Music", Play songs touch function recovery.

2, waiting for the phone does not power automatic shutdown, and then recharge the boot can resume touch screen operation.

3, IPhone 5s connection itunes, upgrade the latest version of the iOS system after the touch screen function will be restored.

What to do about the iphone sliding answering?

Wipe the screen with the entire palm one way 2-3 times (preferably with the Palm peak, that is, the little finger to the wrist part, because the meat is the most flat, and the screen can fully contact.) )。

However, the above measures are palliative and not the root causes, to solve this problem has the following measures:

1, mobile phone do not put trouser pockets, put a jacket pocket or use mobile phone sets

2. If you want to put your trouser pocket, then do not screen inward, because the screen is prone to friction and create static electricity

If it is still unresolved to determine the possible wiring problem, we can refer to the following method to resolve

Phone symptoms

The mobile phone is broken, or the touch part is not normal, for example, the mobile phone backstage can not close, the red part cannot press, the dialing also is not normal.

Specific steps

Step one: Dismantle the machine to begin, need to take out the Cato first, otherwise disassemble the motherboard easy trip.

Step two: The bottom screws out, the back cover to the top slide, open the back cover, remove the motherboard parts of the screws, this time the screw memory board very easy to use.

Step three: When the screen is used to blow the hair dryer, the red part, there is glue.

Step four: Found, is the screen line, touch line has a small part of the bad mouth.

Step five: Finally, assemble back, change screen end, workpiece success! Test camera, bottom speaker, microphone, handset, dial is normal, test normal!

Attention matters

Before dismantling the machine, the card must be removed first, or the motherboard will be broken.

Change the screen to be ready for the hair dryer, the top and tail of the screen to be blown hot, otherwise it will rip off, the screen is very fragile.

Dismantle the machine need to use skillful force, the strength grasps good, otherwise it is easy to demolish the bad, the line position all must pay attention, do not break.