Four key points for configuring the Belkin route Wireless Network

The four key points for setting up Belkin's route wireless network are the four most important points that need to be noticed when setting up wireless networks. This is also a problem that should be noticed in wireless route security settings. Www.2cto.com
1. Disabling DHCP is necessary for wireless routing. Although DHCP can automatically assign IP addresses to each computer in the wireless network, you do not need to set IP addresses, subnet masks, and other required TCP/IP parameters. However, if DHCP is enabled, it is easy for others to use your wireless route, at the same time, it also reduces the performance of the wireless router to a certain extent. Set the DHCP server to Disabled under the DHCP server settings of the wireless router.
2. Disable SSID broadcasting. Generally, the same company uses the same SSID to launch a wireless router and identifies the name of the factory. In fact, this poses a security risk, illegal intruders can know which vro you are using based on your SSID, which can be targeted at cracking. Wireless routers generally provide the SSID broadcast function. If you do not want your wireless route to be searched by someone else using the SSID name, it is best to Disable SSID broadcast, your Wireless route can still be used, but it will not appear in the list available by others. Www.2cto.com 3. Wireless key wireless route encryption protocol is a standard method for encrypting data transmitted in wireless routes. Currently, the most secure encryption method of wireless route routers is wpa2, we recommend that you use some encryption methods, because the traditional WEP encryption is not secure and can be easily cracked.
4. Address filtering is included in the configuration items of the wireless router. When the MAC address filtering function is enabled, note that, in the filter rule, You must select the option to allow only valid MAC addresses in the configured MAC address list to access wireless routes. In addition, if the DHCP function is disabled in the wireless routing LAN, we recommend that you set a fixed IP address for each computer that uses the wireless routing service, and then enter these IP addresses in the IP address allow list, after the IP address filtering function of the wireless router is enabled, only users with IP addresses in the list can access the vro normally, and others cannot access the vro. The preceding figure shows how to set up a secure wireless network.