[Fuzhou has a home decoration] What are the key points for indoor toilet acceptance?

During interior decoration, the installation of the toilet is very important, and the acceptance is also very exquisite. If the installation of the toilet is not standard, it will be annoying later.
As annoying as you can imagine, in the installation process, it is necessary to allow workers to carry out construction in accordance with the specifications to avoid potential risks for future life. Then install the rules
What are examples? Fuzhou decoration company has a home decoration for you to sort out the following five points.
(1) take out the blockage of the ground water outlet, check whether there is no debris in the pipe, and clean around the pipe.
(2) Align the outlet of the toilet with the outlet of the sewer pipe, flatten the toilet, draw a mark at the bolt hole of the toilet, and remove the toilet.
(3) place a hole with a diameter of 20mm and a depth of 60mm at the mark, insert the bolt with a diameter of 10mm into the hole, twist it with cement, and hold the seat
Put the eye on the bolt to make it consistent with the marks, the toilet will be removed after the test. Apply the oil ash around the toilet outlet and sewer
Then, align the four bolt holes in the toilet with the bolts, flat them for correction, place the rubber pads on the bolts, screw the nuts, and tighten the nuts to a moderate degree.
(4) align with the tail center of the toilet, draw a vertical line, draw a horizontal line at a height of 800mm from the ground, according to the two sides on the back of the tank
Position, draw a mark on the horizontal line, and place a hole 30mm in diameter and 70mm in depth at the seal hole. Bolt with a diameter of 10mm and a length of 100mm
Insert into the cave and use cement to twist it. Place the back water tank on the bolt and place it to the center of the toilet. Place the bolts on the rubber pad.
Pad, twist the nut, twist to the tightness.
(5) When the back-tank sewer elbow is installed, remove the nut of the Back-tank sewer and the toilet inlet, and place it in the back-to-back sewer bend.
Head, rubber pads are also set on the sewer. Insert the upper part of the sewer elbow into the lower part of the backtank and the lower part into the toilet inlet.
, Then push the pad to the water outlet, screw the nut, find the water elbow straight, use pliers to tighten to the appropriate.
(6) When connecting to the water with an 8-character door, first measure the size of the floating sub door in the water tank from the upper pipe mouth, configure the short section, install the 8-character door, and enter the upper part.
Pipe mouth. Cut off the copper tube or plastic tube, and place the curved mother in the place of Niang lamps and forks, and then place the front and back nuts of the drifting door and the eight-character door in the copper tube or
On the plastic tube, the tube ends wrapped around the oil asbestos rope or lead oil hemp line, respectively Insert the drift door and eight character door import and export, tighten the nut.
The above six points can be checked and accepted by the toilet, which can reduce a lot of troubles in the future use process.

[Fuzhou has a home decoration] What are the key points for indoor toilet acceptance?