Ghost System to the hard disk after the reboot into the WinXP installation screen becomes a blue screen

Ghost System to the hard disk after the reboot into the WinXP installation screen becomes a blue screen

Cause Analysis:

One, the system integrated driver and the motherboard is not compatible with the failure of this cause is more common in some brands, the main symptom is that the system can be installed properly, but after completion of reboot into the system when the blue screen.

The workaround is also simple: Manually select the driver you want to install when ghost installs. If you are unsure which driver is out of the question, you can choose to not install all. After the installation of the system and then use the motherboard with the CD-ROM drive, you can also download the driver installation online.

Second, the SATA hard drive does not drive the main symptom is that the hard drive is not detected. This causes a lot of trouble to appear in the notebook, and now basically all the books are SATA hard drives. In the installation version of the system installation, you will be prompted to press F6 with the floppy drive to install SATA drivers. The ghost version does not have an integrated serial controller driver, which causes the hard drive to be detected and a blue screen.

WORKAROUND: Each brand BIOS setting is different, but roughly the same meaning. Here is an example of Lenovo Y430. Press F2 to enter the BIOS settings, find the "SATA configurations" option in the "Advanced" option, enter the option, change the setting to IDE, the default setting is AHCI, and change the boot order to boot from the CD drive.

After Setup, the system can be installed in normal steps.

Ghost System to the hard disk after the reboot into the WinXP installation screen becomes a blue screen