H3C and Cisco Fast port comparison

Ciscoportfast This is for the access port, a normal switching interface from down to up to pass: Down,listening,learning,fowarding Several states, total time is 30 seconds, This determines whether this port is blocking or fowarding and is also a mechanism for the switch to prevent loops. However, for direct access to such terminal equipment interface is not necessary to go through these steps, that is, from down directly into the state of fowarding. Basic Configuration method: Sw1 (config) #spanning-tree portfast default (all interfaces enabled) is generally used on switches in the access layer. SW1 (config-if) #spanning-tree portfast Disable (one port disabled, usually a port connected to another switch) H3C basic Configuration Method Interface GIGABITETHERNET1/0/4

This article is from the "Fight for the Dream" blog, please be sure to keep this source http://holger.blog.51cto.com/7969271/1936929

H3C and Cisco Fast port comparison