H3C S3100 switch firmware update

H3C S3100 switch firmware update
1. Set PC and switch Communication
The PC is connected to port e1/0/1, which is divided into VLAN10. Therefore, I configure an IP address in the same network segment for VLAN10 to communicate, but the default Management VLAN of the switch is VLAN1, therefore, we need to cancel VLAN management.

1. Undo interface vlan 1

Then we set our VLAN10 as the management VLAN so that we can add an IP address to the VLAN10.

1. Management-vlan 10

Then go to vlan 10

1. Interface Vlan-interface 10

Configure IP addresses

1. Ip address 192.168.10.200 24

Ping each other and directly connect the PC to the vswitch.


Then download the latest firmware from the official website.

1. Http://www.h3c.com.cn/Service/Software_Download/Switches/Catalog/H3C_S3100/S3100-EI/

Run tftp32.exe on the PC and copy the S31EI *. binfile and S31EI * .btmfile to the running directory of the tftp32.exe program. Run the dir command in normal mode to check the remaining space. The space is about 5 MB. Otherwise, only the previous firmware is deleted:

1. Delete/unreserved s31ei_e-cmw310-r2211p07.bin

Note that there is a recycle bin. Run the following command to clear the recycle bin:

1. Reset recycle-bin

After we have enough space, we can download the firmware:

1. Tftp 192.168.10.196 get S31EI_E-CMW310-R2211P07.bin
   
2. Tftp 192.168.10.196 get S31EI_E-612.btm

Then upgrade:

1. Boot bootrom s31ei_e-612.btm
   
2. Boot-loader s31ei_e-cmw310-r2211p07.bin

After the upgrade, reboot the device.