Hard drive fails boot after boot

Failure phenomenon: The computer on the screen after the message "Device error", and then show "Non-system disk or disk Error,replace and strike any key when ready", the hard drive can not boot. Use CD-ROM boot into DOS, enter "C:" and press ENTER, the screen appears "Invalid Drive Specification" words, can not go to the hard drive.

Troubleshooting: This failure is likely to be the motherboard CMOS hard drive set parameters are missing or hard disk type settings caused by errors, the solution is as follows.

After the boot press del key into the CMOS, check the hard drive set parameters are missing or hard disk type is wrong, if it is can be manually input recovery, if you do not remember the hard drive parameters, you can choose HDD Auto detection items for automatic detection. Some motherboard CMOS due to version stale may not have this option or can not automatically detect the hard drive parameters, then only open the chassis, look at the hard disk surface label on the hard drive parameters to fill out.