How does a tplink router enable remote web management?

SMBVro:

In the System tool-remote WEB management on the vro management interface, set the management address to the public IP address of the remote host (vro) or to 255.255.255.255.

SOHOVro:

On the vro management page, choose security settings-remote WEB management: Set the management address to the public IP address of the remote host (vro) or set it to 255.255.255.255.

 

ERSeries Routers:

On the ER5110 and ER5120 vro management interfaces, choose System Service> WEB server> remote management. Set the remote address range to remote host (vro) or set it to 0.0.0.0/32.

System Tools-device management-remote management on the TL-ER6110/ER6120 router management interface, set the remote address range to a remote host (router) or set it to 0.0.0.0/32.

Note:

1. The default WEB management port of the router is 80. If the default WEB management Port is changed (for example, to 88), you must use the "IP Address: Port" method (for example, http: // 192.168.1.1: 88. This function takes effect only after the vro is restarted. If the vro sets that the virtual server occupies port 80, you must change the management port to a port other than port 80. We recommend that you set the port number to be greater than 1024.

2. The default remote WEB management IP address of a non-ER series router is 0.0.0.0. By default, all computers in the wide area network cannot log on to the router to perform remote WEB management, if the default remote WEB management IP address is changed (for example, to 202.96.12.8), only computers with the specified IP address (for example, 202.96.12.8) in the Wan can log on to the router to perform remote WEB management. If you set the remote WEB management IP address to 255.255.255.255, all computers in the Wan can log on to the router to perform remote WEB management.

3. The default remote WEB management IP address of the ER series router is 0.0.0.0/32. This entry is added by default. All computers in the Wan can log on to the router to perform remote WEB management. If the default remote WEB management IP address is changed (for example, to 202.96.12.8/32), only a computer with the specified IP address (for example, 202.96.12.8) can log on to the vro to perform remote WEB management. At the same time, we can adjust the subnet mask to set the remote WEB management IP address to a network segment (for example, 10.10.10.1/24), then only the IP address of the specified network segment (for example, 10.10.10.1-10.10.10.254) in the wide area network) you can log on to the vro to perform remote WEB management.