The charm of the MX6 the back cover correctly opens the method:
First, use the needle to remove the SIM card from the left side of the MX6 fuselage, as shown in the picture.
Second, the use of a five-angle Phillips screwdriver to the Phantom of the MX6 fuselage at the bottom of the 2 screws removed, as shown.
After removing the two fixing screws at the bottom, we can disassemble the Phantom MX6 screen module by the rod and sucker, as shown in the figure:
Note the cable that the screen is connected to the motherboard
The Charm Clan MX6 dismantle the machine needs to start from the screen, the dismantling difficulty is comparatively bigger, the screen is through the card buckle and the rear cover fixed. In addition, there is a line connection between the screen panel and the motherboard, and you need to disconnect the line at the motherboard interface to complete the screen and back cover separation. Therefore, when the screen panel is removed, do not force too hard, so as not to break the internal line, damage cell phone.
The Phantom MX6 uses a screen-and-back-cover separation design, as shown in which the battery and the motherboard are both located on the rear cover surface.