Tplink Router Extender Setup method
1. Configure the IP address of the connection computer and other parameters are "ip:192.168.1.x Mask: 255.255.255.0 gateway: 192.168.1.1 DNS: Consulting service provider";
2. Configure wireless Router A.
Enable the "Wireless parameters" bridge function, write wireless router B, C, D MAC address (MAC address can be viewed from the device back board stickers), and according to individual needs to modify the SSID and frequency bands;
At the network parameter-wan port setting, set up wireless router A to surf the internet.
3. Configure wireless router B, C, D.
Disable the DHCP server;
Modify LAN port IP address is 192.168.1.X (different device IP);
Enable "Wireless Parameters" bridge function, write wireless router a MAC address, modify the SSID, adjust the band and wireless router a consistent;
4. Finish Setup.
Place the wireless router A, B, C, D at the specified location. Note that B, C, d placement position to be able to better search for a signal;
Operating their own computers wirelessly connected to the wireless router, you can realize wireless sharing Internet.
Tip: The bridge function of different products is the same as the configuration principle, but there is a difference in the configuration interface. Bridge need to pay attention to both sides of the band consistent, as well as fill out the correct wireless MAC address.