Adding a network to the PCB in DXP is divided into two steps: Generating a network Table file and adding networks to the PCB based on the network table file
1. Generate the network table file:
Click <design>→<netlist>→<create netlist from Connected Copper>, you can generate net file, save well;
2. Add the network to the PCB according to the network table file:
1) Add the network table files generated in 1 steps to the project file, as shown in the figure:
2) Click the right mouse button in the project file as shown in the image above, then in the dialog box <show Difference>, will jump out of a window, in the pop-up window will <advanced mode> a √, as shown below
3) left selected. NET file, select the PCB file on the right, click <ok>, as above, then select <yes> in the pop-up dialog, and jump out of the Diagram dialog box:
4) in the image above, you can see that the button in the lower left corner is gray, right-click in the blank of the above image, select < update all IN>>PCB document, and then click the button in the lower left corner to go out the following dialog box:
5) Click <validate Changes>, and then click <execute Changes>, you can see the PCB in the presence of the flying line;
6) Last step <design>→<netlist>→<update free primitves from component Pads>, fly line disappears, network add success, congratulate you.