How Plink router wdr8500 is used under other routes

Tplink Router wdr8500 connect to other routes using step one, login management interface

1. Connecting computers and routers

The setting computer is connected to the tl-wdr8500 LAN port through a network cable, as shown below.

Attention. To avoid IP addresses or DHCP server conflicts, do not connect tl-wdr8500 to the front-end network here.

2, Login Management interface

Open the browser, empty the address bar, enter the admin address tplogin.cn, as follows.

Set the management password for the router (if it is already set, please enter the password directly), click OK.

3, enter the routing settings

Click the Skip Wizard, as shown below.

After entering the admin interface, click on the routing settings below.

Tplink Router wdr8500 connect to other routes using step two, modify wireless parameters

Click on the wireless settings, as shown below.

Set the wireless name and wireless password of the 2.4G and 5G network respectively, click Save, as shown below.

Attention. Wireless name does not recommend the setting of Chinese or special characters, wireless password at least 8 digits, in order to ensure network security, strong password to ensure the strength.

Set the wireless signal and password for the 5G band in the same way.

Tplink Router wdr8500 Connect under other routes use step three, modify LAN port IP address

Click the LAN port setting to change to a different IP address from the same network segment as the main router.

For example, the LAN port IP of the primary router is 192.168.1.1, the IP of this router is modified to 192.168.1.X (x=2-254). The primary router is 192.168.0.1, the router is modified to 192.168.0.X.

After saving, the computer will retrieve the IP address and click OK.

Attention. Subsequent login router management interface, you need to use the modified IP address login, please keep in mind.

Tplink Router wdr8500 Connect under other routes use step four to shut down the DHCP server

Use the modified IP address or tplogin.cn login router interface, click Routing Settings >> DHCP server, click Off, as shown below.

Tplink Router wdr8500 connect to other routes using step five, follow the topology connection line

All settings are complete, and the tl-wdr8500 LAN port (that is, the 1~4 interface) is then connected to the LAN port (or LAN switch) of the front-end router.

At this point, tl-wdr8500 as a wireless switch (wireless AP) use has been set up, wireless terminals can be connected to set up a good wireless signal network. If you have a wired computer that requires Internet access, connect to a LAN port.