Many friends feel that the notebook's hard disk is not enough, and do not like to use mobile hard disk, so I want to change a hard disk notebook, but do not know how to install the hard drive notebook, the following to introduce you.
1. Unplug the battery on your laptop before you install the hard drive to dismantle the machine. In this way to avoid in the disassembly or when the hard drive is installed due to the key or the internal vibration caused by the computer to boot, if you are operating the installation of a hard drive this step can be burned on the hard disk interface or the motherboard on the hard drive interface.
2. Then put the screws on the back cover down, it is best to check whether the screws have been removed, if there is no demolition is not open. Then in the back cover open place, there is a gap is good to break off on the open, the first time may feel more difficult to open, the strong point is not related to open.
3. When you open it, you can see the black and boxy things are hard drives. Take a certain screwdriver up a bit, the hard drive directly up to lift can be taken out.
4. After the hard disk components are taken out, this connection to the motherboard place can be pulled out on one. Connectors must leave a message good this to install to the new hard drive up.
5. Then remove the screws on the hard drive assembly and install the new hard drive.
6. The fixed shell of the notebook is installed and then the joint is installed. Then put this set from the top down into the notebook board interface on it.
7. In the installation of the lid should be noted that the general lid will have one side is first installed to the notebook computer up, and then put it together. This method is relatively simple as long as you see the prominent place on the lid is not the first installation side. This completes the installation of the portable hard disk.