How to create a line in the Ansys?

How to create a line in the Ansys? This experience is to share an article on how to use the Ansys to create lines.

First, the preparation work of Ansys

1, first, double hit Open ansys12.0, the other version of the ANSYS can use the tutorial, as long as the classic interface to the ANSYS. Then we choose the work path and file name, click Run to enter the working interface of the ANSYS.

2, click Utility Menu>file>change Jobname, after the pop-up dialog box, input file-lines, click Yes, and then click OK, as shown in the following figure. (Command line:/filename)

3, click Utility Menu>file>change Title, pop-up dialog box, we can enter example, click OK to complete the definition analysis title. (/title command) (right mouse, select Replot, will refresh, you will see the lower left corner appears File-lines)

Second, the creation of lines

1, create the line before, must create a point, after all, Ansys is not a professional drawing software, Main Menu>preprocessor>modleing>create>areas>keypoints>on Working plane, enter the origin coordinates 0, 0, and then create a second point in the in active CS, and the coordinates of the points are 10,10,0.

2, create a line, shortcut input command, l,1,2, you can create a straight line.

3, create the arc, change the column coordinate system, as shown in the following figure. Create point 3 and then in main Menu>preprocessor>modleing>create>areas>lines>arcs>by end Kps&rad, select point 1, 2 Click OK to select the point 3 below, the size of the input radius can be completed.