How to create multiple configuration items for a single receng and diskless package

How to create multiple configuration items for a single receng and diskless package

This is a 95% similar practice on the Internet: no reference, this is a post. Many friends of wangmeng are always asking how to perform multiple configurations in a single package. I have also tried multiple tests. Chapter. The test is very successful. Resend this article! If you have any questions, post them and provide detailed answers. 1. First, perform the pre-installation plan. According to the different situations of Internet cafes, several hardware configurations are required. Eight configurations are required. 2. Add these eight configurations to the server 001 ~ 008. It is recommended to write the motherboard configuration in the description and add as the backup. Use configurations to prevent temporary motherboard replacement. 3. Create a system master disk and find a master disk that belongs to the most configured machine. Different Internet cafes use different methods. Install the operating system and install patches (we recommend that you install SP2 without patching), install the corresponding driver and input method, and then Perform some optimization operations. The program is recommended to be installed later, so that the system master disk is very small, usually more than 1 GB, upload speed Fast. 4. Upload the system. Check whether the master disk has been optimized before uploading. You can install the disk-less client software, You need to restart the system twice to find the RAID driver. And set the Super User for this instance on the server. After restart In computer management, check whether the disk mapped to the diskless server can be found correctly. If the disk was previously created, you only need to format the disk. Be sure to confirm before the disk, Do not take the game partition out. Of course, the 1.5 version usually uses only one single image as the system disk, There is nothing to say. Upload the system in the diskless software before formatting, and select the hardware configuration number. 001, Click Upload. This process usually takes several minutes. 5. Remove the hard disk. Be sure to save the hard disk for later use. Start with diskless boot. After startup, run Copy configurations in the row-less software to 002 ~ , Shut down after the replication, and then shut down the Super User. 6. Select a machine with the configuration of 002 and set it as a super user on the server. It can be started with no disk. Three situations: A. It can be started normally, but it is slow. You need to find the hardware device on your own. Do not panic and wait slowly, especially in When the sound card driver is different, it will be suspended. If the machine does not reflect it in 10 minutes, it will be restarted once manually, and it will be normal. Install other drivers. Generally, the bus is automatically searched for and installed. Generally, sound cards and video cards need to be manually installed, The premise is that you do not need to manually install it if it is automatically installed. B. It cannot be started normally. The progress bar is always running in the place where the XP progress bar appears, or the system restarts automatically after two laps. This In this case, you need to mount the hard disk of the original upload system to the machine, start it with the hard disk, install the driver, and upload it with updates. C. In the above case, B. The difference is that the hard disk cannot be started into XP, and the hard disk needs to be mounted back to the original upload. Remove the hardware driver from the system machine (first uninstall the network adapter, and universal serial bus controller, and sound, video game Control, monitor, display card, right-click when uninstalling, and click unmount .. Change the computer's advanced The configuration Power Interface (ACPI) attribute is standard PC... Replace your local ide ATA/atapi The Controller is changed to a standard dual-channel PCI ide Controller), and then mounted to a machine that cannot be started. Update and upload after the driver is installed. 7. Repeat Step 1 and install the application after all configurations are properly started.