How to draw half an egg in PPT

How to draw half an egg in PPT

This article on the use of PPT to draw half an egg case, is the largest project, the time may be longer. But if you have to follow the previous series of PowerPoint tutorials, especially the shape-drawing class tutorials, you won't find it difficult. You will be quite proud to see yourself doing this with your PPT. Finish the PPT to draw half an egg this effect, ppt shape to draw the various operations for you is already as simple as usual!

1, using the Ellipse tool to draw an ellipse and rotate a certain angle (the following figure rotation angle is 327°).

2. Set the linear gradient for the ellipse, and remove the contour line. The gradient angle and the aperture cursor position are shown in the figure.

3. Select three cursors on the gradient aperture respectively, set the color for them, from left to right, the RGB values are as follows:

4, after the completion of the setup, the ellipse becomes the following look.

5, and then draw a larger circle some of the ellipse, right click, in the menu select "On the ground floor", we will use this oval to make eggshell.

6, the newly drawn ellipse is set to no outline, the same gradient fill. The gradient angle and the cursor position are shown in the figure. This time we only use two cursors.

7. Select two cursors on the gradient aperture respectively, set the color for them, from left to right, the RGB values are as follows:

8, after the completion of the set, the overall effect of the two ellipses into the following look.

9, draw a rectangle, rotate to the appropriate position, the oval as the eggshell block unwanted left upper part, leaving the lower right part of the need.

10, hold down the CTRL key, select as the shell of the large oval and rectangular (order can not be wrong), using the "merge shape-cut off" to get the following figure effect.