How to log on to a Huawei router on a Super Terminal

How to log on to a Huawei router on a Super Terminal? Generally, we can use telnet commands to log on to a vrotelnet. Of course, this command can be used only after it is set, before that, we used the Super Terminal to log on through the Console port. This is what we will talk about below.
1, physical connection 1, the configuration of the cable DB-25 plug to the computer to configure the router serial port. 2. Connect one end of the RJ-45 of the configured cable to the Console port of the router. 2. Set the computer parameter www.2cto.com 1. Open the computer, run the terminal simulation program on the computer, and run the Windows Super Terminal. 2. Set terminal parameters, set the baud rate to 9600, data bit to 8, parity to none, stop bit to 1, traffic control to none, and terminal simulation to VT100. (1) In the super terminal window, click Properties.
(2) Select the connected serial port in the connection column in the Super Terminal Properties dialog box. The selected serial port should be consistent with the serial port configured for the cable connection, and click Configure.
(3) In the Properties dialog box of the serial port, set the baud rate to 9600, data bit to 8, parity to none, stop bit to 1, traffic control to none, and click OK.
(4) In the Super Terminal Properties dialog box, select Settings to enter the properties settings window, select terminal simulation as VT100, and click OK.
Now the configuration has been completed. After powering on the vro, you can log on to the Super Terminal.